TDS JOINT SEALING TAPE-2000-S_022425.pdf
2 Pages
61.2 KB
Download
<h1>TDS JOINT SEALING TAPE-2000-S_022425.pdf</h1> <p>AQUAFIN Inc. <br />505 Blue Ball Rd. #160 <br />Elkton, MD 21921 <br />p: 410-392-2300 <br />e: info@aquafin.net <br />e: technical@aquafin.net <br />w: www.aquafin.net</p> <p>Technical Datasheet</p> <p>AQUAFIN® JOINT SEALING TAPE-2000-S <br />For expansion/control joints and cracks in concrete water structures <br />CSI Div. 07 <br />07 16 13 Polymer-modified Cement Waterproofing <br />LEED Points <br />IEQ Credit 4.2, Low-Emitting Materials Paints and Coatings...1 Point <br />Using this AQUAFIN product can help contribute to LEED certification of projects in the category <br />shown above.</p> <p>Product Description: <br />JOINT SEALING TAPE-2000-S is a state-of-the-art, highly tear resistant, <br />waterproofing tape which prevents the passage of moisture and water <br />through concrete joints and cracks. <br />Typical Applications (positive side only): <br />• Expansion/control joints in concrete: <br />- Below grade foundations <br />- WTP (water treatment plants) and WWTP (waste water <br />treatment plants) <br />- Water tanks (2K/M stand alone only) <br />• Cracks in concrete: <br />- Below-grade foundations <br />- WTP (water treatment plants) and WWTP (waste water <br />treatment plants) <br />- Water tanks, underneath tiles <br />• Change in plane tile applications over concrete (refer to <br />TCNA guidelines) <br />Advantages: <br />• NSF/ANSI 61 potable water approved <br />(when used with AQUAFIN-2K/M) <br />• Quick and easy installation <br />• Waterproof <br />Substrate Preparation: <br />Refer to 2K/M Technical Data Sheet. <br />Product Application: <br />JOINT SEALING TAPE-2000-S is bonded to concrete with <br />AQUAFIN-2K/M flexible cementitious waterproofing material. <br />Refer to the AQUAFIN-2K/M Technical Data Sheet for mixing and <br />application instructions. <br />Apply first (base) coat of AQUAFIN-2K/M, extending a minimum of <br />3/4” (20mm) beyond either side of tape. Immediately embed JOINT <br />SEALING TAPE-2000-S into the first coat uniformly, leaving no wrinkles, <br />using a trowel or similar tool. To connect tapes, after installing the first tape, <br />overlap a second tape a minimum of 4” (100mm) using AQUAFIN-2K/M. <br />Allow 3 to 4 hours to cure. Then, cover the JOINT SEALING <br />TAPE-2000-S with a second coat of AQUAFIN-2K/M and smooth the <br />surface with a damp brush. In expansion joints, allow as much slack in the <br />tape as needed to allow joint movement.</p> <p>Check our website for the latest version of the Technical Datasheet. <br />www.aquafin.net</p> <p>Technical Data: <br />Product: <br />JOINT SEALING TAPE 2000-S <br />Material: <br />membrane embedded in fabric backing <br />Color: white <br />Thickness: <br />20 mils <br />VOC Content: <br />0 <br />UV Resistance: <br />>500 hrs. (DIN EN 150 ISO 4892-2) <br />Elongation: <br />600% (ASTM D-638) <br />Tear Resistance: <br />2,175 psi (15.0 MPa) <br /> <br />(ASTM D-2240 - modified) <br />Temperature Resistance: <br />-8˚F (-22˚C) to 194˚F (90˚C) <br />Alkali Resistance: <br />• Resistant against boiling in sodium hydroxide with a pH of 12 <br />• Resistant against boiling in 2% potassium hydroxide (minimum <br />10 minutes) <br />• Waterproof - resistant to hydrostatic pressure <br />Other Resistances: <br />• Highly resistant against oil, grease and solvents <br />• Good weathering resistance <br />• Excellent decomposition resistance (microbes) <br />• Good UV resistance</p> <p>Packaging: <br />• 4¾” (120 mm) x 164 ft. (50 m) rolls <br />shipping weight: 5 lbs. (2 kg.) <br />• 8” (200 mm) x 164 ft. (50 m) rolls <br />shipping weight: 8 lbs. (3.5 kg.) <br />Yield/coverage: <br />A 46 lb. (21 kg) unit of AQUAFIN-2K/M adheres <br />approximately 85 ft. of 4¾” wide tape or approximately <br />57 ft. of 8” wide tape. <br />Actual coverage may vary due to substrate conditions. <br />Limitations: <br />• Do not use AQUAFIN JOINT SEALING TAPE-2000-S in negative side <br />applications exposed to direct hydrostatic pressure. <br />• Do not use AQUAFIN JOINT SEALING TAPE-2000-S in pools, hot tubs, <br />fountains, similar water structures, or any areas exposed to chlorinetreated water. <br />• Do not use AQUAFIN-1K as an adhesive for AQUAFIN JOINT <br />SEALING TAPE-2000-S. <br />Shelf Life: <br />Two years, when stored in a dry, enclosed area, in original packaging. <br />Note: <br />Proper application is the sole responsibility of the user. Applicators are <br />expected to follow ICRI and ACI guidelines as well as other applicable <br />industry standards. Aquafin personnel or representatives are not site</p> <p>Page 1 of 2</p> <p>(2/24/2025-EKVBAC)</p> <p>AQUAFIN® JOINT SEALING TAPE-2000-S <br />inspectors or construction project managers and therefore do not approve <br />surface preparation, mixing, or application of Aquafin products. Site visits <br />by Aquafin personnel or representatives are solely for the purpose of <br />making technical recommendations, not for providing supervision or quality <br />control. <br />General Information: <br />All details in particular to the suggestions for the processing and use of the <br />product is based on our present knowledge and experiences at the time <br />of printing. Depending on specific applications, in particular regarding <br />substrates, processing and environmental conditions may affect final results. <br />Health & Safety: <br />Refer to MSDS. <br />LIMITED WARRANTY: AQUAFIN, INC. warrants this product for a <br />period of one year from the date of installation to be manufactured free of <br />defects and to be consistent with its technical properties as stated in our current Technical Data Sheet. This product must be used as directed and within <br />its stated shelf life. AQUAFIN INC. will replace or at our discretion refund <br />the purchase price of any product, excluding cost of labor, which is proven <br />to be defective. Our product recommendations are based on industry standards and testing procedures. It is the buyer’s obligation to test the suitability <br />of the product for an intended use prior to using it. We assume no warranties written, expressed or implied as to any specific methods of application <br />or use of the product. AQUAFIN INC. MAKES NO WARRANTY AS TO <br />MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE AND <br />THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES EXPRESS OR <br />IMPLIED. AQUAFIN, INC. shall not be liable for damages of any sort including remote or consequential damages, down time, or delay. Any claim for <br />a defective product must be filed within 30 days of discovery of a problem, <br />and must be submitted with written proof of purchase. <br />For Professional Use Only.</p> <p>Check our website for the latest version of the Technical Datasheet. Only the current version is legally binding - and only for the intended market. In cases of uncertainty contact <br />our technical department for further information before starting any applications. <br />Page 2 of 2 <br />www.aquafin.net <br />(02/24/25-EKVBAC)</p>
